2021-07-09
Вториот тип: вертикаленмашина за вбризгување калапи
In this type of машина за вбризгување калапи, the clamping part and the injection part are on the same vertical centerline, and the mold is opened in the vertical direction. Therefore, it occupies a small area, it is easy to place inserts, it is convenient to load and unload molds, and the materials falling from the hopper can be plasticized more uniformly. However, the product is not easy to automatically fall after being ejected, and must be removed by hand, which is not easy to realize automatic operation. Vertical машини за вбризгување калапи are suitable for small машини за вбризгување калапи. Generally, машини за вбризгување калапи below 60 grams are more commonly used, and large and medium-sized machines are not suitable.
The third type: Angle машина за вбризгување калапи
The injection direction of the angle машина за вбризгување калапи is on the same surface as the mold interface. It is particularly suitable for processing flat products where gate marks are not allowed in the machining center. It occupies a smaller area than a horizontal машина за вбризгување калапи, but the inserts placed in the mold are easy to tilt and fall. This type of машина за вбризгување калапи is suitable for small machines.
The fourth type: multi-mode turntable машина за вбризгување калапи
Тоа е посебномашина за вбризгување калапи with multi-station operation. Its characteristic is that the mold clamping device adopts a turntable structure, and the mold rotates around the shaft. This type of машина за вбризгување калапи gives full play to the plasticizing capacity of the injection device, which can shorten the production cycle and increase the production capacity of the machine.